Non-Standard & Custom Fasteners
Cold-headed, turned and stamped fasteners to drawing: shoulder bolts, weld studs, captive screws, security screws and assembly-specific parts that no DIN standard covers.
Also searched as: custom fasteners, non-standard bolts, special screws, cold headed parts, fasteners to drawing
Send a drawing, a sample or an OE number and we quote this part type to it. The selection data below is what the quote is built from.
What decides the price
In order of impactA cold-heading die is a one-off cost that only makes sense above a certain volume. Below it, turning is cheaper per piece.
Cold heading, turning or stamping give different strength and surface results. The route is chosen from the drawing, not from habit.
A special part is only as good as its first-article report. Without one, you are buying the first batch blind.
Worth checking before you order
A drawing without tolerances gets quoted to general tolerance, and general tolerance is usually not what the assembly needs.
Pay for the die after you have approved a turned prototype, not before.
Selection data
Confirmed per orderQuoted to your specification
Send a drawing or a samplePart numbers for this subcategory are quoted to order. Send the size, grade and finish you need, or a drawing, and we quote against that.
Questions
Can you make from a sample instead of a drawing?+
Yes. We measure the sample and send a drawing back for you to approve, so both sides quote and inspect against the same document.
Who owns the tooling?+
Whoever pays for it, stated in writing before it is cut. We do not hold tooling hostage.
Send the specification, not the product name.
Grade, size, thread standard and coating are what a quote is built from. A product name alone produces a price that changes twice before the order.